DIY Hot Glue Mold


Just expressing the cloudiness the parchment paper gives you ๐Ÿ˜‰ And that the pieces are firm ๐Ÿ˜‰ Parchment paper ๐Ÿ˜‰ Dollar Tree shot cups ๐Ÿ™‚ Disclaimer: Handle Resin in a well-ventilated area. Pour the resin container into their own cup, and make them both equal in the amount poured. I am going to pour the thinner liquid on top of the thicker, because that is what you usually should do if you are pouring them both into one pre-measured cup. Gently stir for 2 min., scraping the sides, until the lines/striations in the liquid are gone. Let sit for 5 min. to let the bubbles rise. Make sure to let the hot glue chill before adding another layer, or it will just combine with the first layer. I did 3 layers Just rubbing out stringed glue lol Add a little indirect heat to the resin, it will pop the bubbles. Let sit for at least 12 hrs, don’t forget to cover it. Cut off the glue while it is still flexible it will go back to its original form, and cut off uneven edges. Add more resin to get rid of the cloudiness, let sit for at least another 8 hours, and you’ll have a glossy finish. If you don’t have that patience use mod podge dimensional magic, and rub a thin coat. Please Like, Share, and Subscribe! ๐Ÿ™‚

Dereck Turner

Leave a Reply

Your email address will not be published. Required fields are marked *